57
W&T The basis configuration of the Com-Server
Subject to error and alteration
8�2 Menu: INFO System
This menu allows you to call up device-specific parameters
such as the version njmber and creation date of the firmware,
MAC address of the unit, etc.
n
Cable type
Indicates whether the connection to the hub/switch is
using 10BaseT or 100BaseTX. The duplex procedure is
also indicated (Full- or Half-Duplex).
n
MAC address
Shows the Ethernet address of the Com-Server. This num-
ber is factory set and registered. It cannot be changed.
n
SOFTW Date/Rev�
Shows the creation date and version number of the opera-
ting software in flash.
n
HARDW Rev�
Shows the version status of the Com-Server hardware.
n
Run Time
Shows the time in hours and minutes since the last Com-
Server restart.
To Next Page
Loading...
