W&T Com-Server++ - Optional Settings

102
W&T Mode TCP client
12�1�3 Optional settings
Using the following optional settings in the submenu ...TCP
Client r Special Options various special functions can be ac-
tivated and deactivated. These apply both for operation with
fixed or serial addressing.
Response Mode (Default: deaktiv)
SETUP Port x
TCP/IP Mode
...
TCP Client
...
Special Options
Response Mode
In Response Mode the application is informed of the net-
work-side connection status of the Com-Server in the serial
terminal device by the output of special characters. This
function is only available in TCP client mode.
The following messages are output on the serial port:
C
(connected)
The connection was successfully opened. There is a
TCP connection to the server.
N
(not connected)
The connection was not successfully opened. There is
no response from the TCP server.
D
(disconnected)
The connection attempt was rejected by the TCP ser-
ver, or a previously existing connection was normally
closed by the TCP server or Com-Server.
Ixxx�xxx�xxx�xxx (invoked by ...)
A client application on the indicated station successful-
ly opened a TCP connection to the Com-Server (e.g.
172.20.20.1).