W&T Com-Server++ - Factory Default Settings

12
W&T
1�3 Factory defauls settings
The list contains an overview of the most important settings.
For many applications, such as the W&T COM Port Redirector,
no additional configurations need to be made besides assig-
ning the network base parameters. Detailed information on
the respective parameters can be found in later sections of
this manual.
Network settings
Hardware connection: Auto negotiating
IP address: 0.0.0.0
Gateway address: 0.0.0.0
Subnet mask: 255.0.0.0
DHCP: Active
1
To prevent unintended address assignments or
changes, we recommend deactivating the DHCP protocol
if it is not expressly used in the respective network environ-
ment.
Serial settings
Hardware connection: RS232
Baud rate: 9600
Data bits: 8
Parity: NO
Stop bits: 1
Handshake: None
Fifo: OFF
Configuration access
Per Telnet using TCP port 1111
Network applications / Operating mode
(suitable for use with W&T COM redirector)
TCP server ports, port no. A-C: 8000, 8100, 8200
Control port TCP, port no. A-C: 9094, 9194, 9294