W&T Com-Server++ - Default Chapter; Table of Contents; Ethernet Interface

W&T
Content
1 Quickstart ���������������������������������������������������������������� 9
1.1 Flow chart – Network installation using WuTility ............... 10
1.2 Overview of configuration menu ...................................... 11
1.3 Factory defauls settings ................................................... 12
2 Assigning the IP address ��������������������������������������� 13
2.1 Configuring network parameters with WuTility ................. 14
2.2 Assigning the IP using DHCP protocol .............................. 17
2.2.1 Manual activation of DHCP ..........................................17
2.2.2 System name ..............................................................18
2.2.3 Lease time ..................................................................18
2.2.4 Reserved IP addresses .................................................19
2.4.5 Dynamic IP addresses .................................................19
2.3 Assigning the IP using the ARP command ........................ 20
2.4 Assigning the IP using the serial port ............................... 23
2.5 IP Address Conflict Detect ................................................ 25
3 Supply voltage ������������������������������������������������������� 27
3.1 Supply voltage 58665 ...................................................... 28
3.1.1 Power over Ethernet ....................................................28
3.1.2 External supply ...........................................................28
3.1 Supply voltage 58662 ...................................................... 29
4 Network interface �������������������������������������������������� 31
4.1 Ethernet interface ............................................................ 32
5 The serial combi-port ��������������������������������������������� 35
5.1 Overview .......................................................................... 36
5.1.1 Opening the Com-Server .............................................36
5.1.2 Mode selection ...........................................................36
5.2 RS232 mode (factory default) ........................................... 37
5.3 RS422/485 mode ............................................................. 38
6 LED displays ���������������������������������������������������������� 41
6.1 LED displays .................................................................... 42
7 Configuration access to the Com-Server ����������������� 45
7.1 Configuration menu structure .......................................... 46
7.2 Configuration via Telnet................................................... 48
7.2.1 Navigation within the Telnet menu ..............................48
7.3 Configuration via Browser - Web Based Management ........ 50
7.3.1 Activating WBM with the WuTility-Tool ........................50
7.3.2 Activating WBM via the serial interface ........................50
7.3.3 Activating WBM from the configuration menu..............51
7.3.4 Starting and navigating the WBM .................................52