W&T Com-Server++ - UDP Client Mode with Fixed Destination

112
W&T Mode UDP peer
13�1�2 UDP clientmode with fixed destination system
SETUP Port x
TCP/IP Mode
...
UDP Client
...
Server Port
Server IP/URL
n Server Port
Port number that the application (TCP server process)
addresses on the computer.
Format: decimal
n
Server IP/URL
IP address or URL of the computer on which your applicati-
on (TCP server process) is active.
Format: Dot notation or URL
1
A URL can only be assigned in conjunction with a
valid DNS server. The name used is not allowed to
contain space characters (0x20), nor can the first cha-
racter be a decimal (0x2E). A server IP or URL is deleted
by entering 0.0.0.0. For additional information refer to
the section Menu: Setup SYSTEM r Setup TCP/IP r DNS-
Server.
All incoming serial data are sent to the configured destination
system in UDP datagrams. Without using Packet Options you
cannot affect the network-side division of the data into UDP
datagrams. To ensure that serially associated data blocks are
also sent closed in a UDP datagram, Packet Options offers
possibilities for parameterizing serial packet limits (pause
times, start-/end sequences, lengths). For details, see the sec-
tion Packetizing serial datagrams.