16
W&T Assigning the IP address
Step 2: Assign the IP parameters
The Static option allows you to assign fixed basic parameters
while simultaneously disabling DHCP and BOOTP protocols
in the Com-Server. Enter the desired values for IP address,
subnet mask and gateway address in the corresponding entry
fields. The DHCP option enables DHCP protocol in the Com-
Server, and operation with a static IP address is no longer
possible (see IP Assignment using DHCP Protocol for detailed
information)
If the remaining configuration of the Com-Server is done
using a Web browser, activate the option Web-Based-Manage-
ment (WBM). If you are not using the standard HTTP port 80,
change the port number to the desired value.
Clicking on the Next button assigns the network parameters
to the Com-Server. After acknowledging the resulting mes-
sage, all the columns in the WuTility device list are filled in
with information.
If necessary, the remaining configuration of the Com-Server
is done using Telnet or Web-Based-Management. Click on the
Telnet or Browser button.
Telnet:
Browser:
Additional information can be found in the section Configura-
tion Accesses for the Com-Server.
To Next Page
Loading...
