W&T 58665 - Page 5

5
W&T
Subject to error and alteration
8 The basis configuration of the Com-Server ������������ 55
8.1 Save your settings ............................................................56
8.2 Menu: INFO System
.......................................................... 57
8.3 Menu: SETUP System ........................................................ 58
8.3.1 Menu: SETUP System r Setup TCP/IP...........................58
8.3.2 Menu: SETUP System r System Password ....................62
8.3.3 Menu: SETUP System r System Name
..........................63
8.3.4 Menu: SETUP System r Logfile
....................................63
8.3.5 Menu: SETUP System r Flash Update
...........................65
8.3.6 Menu: SETUP System r Factory Defaults
.....................65
8.3.7 Menu: SETUP System r Reset ......................................65
8.3.8 Menü: SETUP System r Link Speed
..............................65
8.4 Menu ... r TCP/IP Mode r System Options ......................67
9 Configuration of the serial port ����������������������������� 69
9.1 The serial parameters (Menu: UART Setup) .......................70
9.1.1 Baud rate, Data bits, Stop bits, Parity ..........................70
9.1.2 The handshake modes
................................................71
9.1.3 Receive Buffer (InQueue) .............................................75
9.1.4 FIFO Send/Rec (only Com-Server 3x Isolated) ..............75
9.2 TCP-/UDP port numbers (Menu: TCP/IP Mode) ..................77
10 Packetizing serial datagrams ��������������������������������� 79
10.1 Packet Options ...............................................................80
10.1.1 Startsequence/Endsequence .....................................81
10.1.2 Startsequence + Lengthfield
......................................84
10.1.3 Interpacket Delay
......................................................86
10.1.4 Fixed Packet Length
..................................................87
11 Mode TCP-Server ���������������������������������������������������� 89
11.1 The Com-Server as TCP server .......................................90
11.1.1 Configuration of the local port number .....................91
11.1.2 Optional settings
......................................................91
12 Mode TCP Client ����������������������������������������������������� 95
12.1 The Com-Server as TCP client .........................................96
12.1.1 TCP client mode with fixed destination system .........97
12.1.2 TCP client mode with serial addressing
...................100
12.1.3 Optional settings ....................................................102
12.1.4 Deactivating TCP client mode
..................................105
12.1.5 Application: Client/Server mode
..............................105
13 Data transfer per UDP ������������������������������������������ 109
13.1 Der Com-Server als UDP-Peer .......................................110
13.1.1 Setting the local UDP port number ..........................111
13.1.2 UDP clientmode with fixed destination system
........112
13.1.3 UDP client mode serial addressing
..........................113
13.1.4 Optional settings ....................................................115