Ⅰ. Set up unit price for electricity cost:
Press “MENU” button for 5~10 seconds, when the screen shows “Pr.” and “ST” on the
bottom, “ST” flickers, and unit shows “$”, figures show the unit price for electricity(as
shown below); figures (unit price) can be changed by pressing "UP" or "DOWN" button.
When setting is completed, press "MENU" button again, thus price setting is completed.
Ⅱ. Set up ratio of operation condition
Press “MENU” button for 5~10 seconds, when the screen shows “RT” and “ST” on the
bottom, “ST” flickers, and unit shows “%”, figures show the ratio of operation
condition(as shown below); figures can be changed by pressing "UP" or "DOWN" button.
When setting is completed, press "MENU" button again, thus the ratio of operation
condition is set.
III. Set up standby power
Press “MENU” button for 5~10 seconds, when the screen shows “PW” on the top and
“ST” on the bottom, “ST” flickers, and unit shows “W”, figures show the standby power(as
shown below); figures can be changed by pressing "UP" or "DOWN" button. When
setting is completed, press "MENU" button again, thus the ratio of operation condition is
set. Standby power is usually stated on appliance or its user manual; users can set up
standby power on the ammeter accordingly (a bit higher than the stated one on appliance
is better).This product will automatically monitor the operation condition of appliance
according to the set standby power and the ratio of operation condition, as well as give
out alarm accordingly.
IV. Clearance of records
Press and hold “UP” button for 10~15 seconds to clear accumulated record into 0,
including all accumulated records in all operation periods;
Press and hold “DOWN” button for 10~15 seconds to clear records in single operation
period into 0, including all calculated records in single operation period.
To Next Page
Loading...