Need help?Do you have a question about the Wanner Engineering Hydra-Cell H-25 and is the answer not in the manual?
General| Model | H-25 |
|---|---|
| Pressure | up to 2500 PSI (172 bar) |
| Flow Rate | 25 GPM (94.6 LPM) |
| Power Source | Hydraulic |
| Material | Stainless Steel |
| Inlet Port Size | 1.5 inches |
| Seal Type | Seal-less design |
| Weight | Varies depending on configuration (Consult factory) |
| Horsepower | Varies depending on hydraulic motor (Consult factory) |
To Next Page
