Wansview Cloud APP User Manual
www.wansview.com
16
5.5.5 Diagnose
If your camera can’t pair success or the APP have any breakdown, user can tap this page to allow the built-in
diagnostics system running to check problem. User could provide the diagnostic report to Wansview Support
to ask for suggestions.
5.5.4 Device Management
User can restart the camera or restore the camera to factory settings by tapping this icon directly. You can
delete the camera from here too. After deleting, the previous data will be defaulted to zero.
Please note that the camera should be set up again as new if the camera is restored to the factory settings
or being deleted from the Device page.
To Next Page
Loading...
