How to fix a WAREMA Control System when sun shading system moves up too late in cloudy weather?
If the sun shading system moves up too late in cloudy weather, the HIGH limit value might be set too high in the sun control settings. Try changing the limit value.
Why doesn't my WAREMA Wisotronic Control Systems respond to the EWFS Hand-held transmitter?
If the WAREMA Wisotronic does not respond to an EWFS Hand-held transmitter, ensure the transmitter has been learned in. If using an 8-channel EWFS transmitter, verify the correct channel is selected and repeat the move command. Also, ensure the button press isn't too short and repeat the command if needed. Reduce the distance to the Wisotronic to avoid interfering ambient influences. Check for active safety functions due to weather conditions and wait until they subside. If a wind test identified a fault, reset the wind test.
Why does my WAREMA Wisotronic Control Systems respond sporadically to the EWFS Hand-held transmitter?
If the WAREMA Wisotronic responds only sporadically to an EWFS Hand-held transmitter, try reducing the distance to the Wisotronic to avoid interfering ambient influences. Also, check for interference from external transmitters such as baby monitors, and switch them off.
What to do if control functions do not respond on my WAREMA Wisotronic Control Systems?
If the control functions of your WAREMA Control Systems do not respond, first check if the control functions are deactivated on the control panel. If so, activate control functions in the main menu and in the comfort functions. Another reason may be that a safety function is active.
What to do if the WAREMA weather station or actuator cannot be learned in?
If the weather station or actuator cannot be learned in, ensure that there is bus device voltage and correct the connection if necessary.
What to do if there are uncontrolled movements of WAREMA Wisotronic Control Systems connected products?
If you experience uncontrolled movements, it might be because changes were made to the bus parameters but not transferred to the bus devices; in this case, reload the devices. Alternatively, a temporary power failure/restart may have occurred, requiring a calibration after the power is restored.
How to fix WAREMA Wisotronic not responding to an EWFS Hand-held transmitter?
If your Wisotronic isn't responding, first ensure the transmitter has been learned in. If you're using an 8-channel EWFS transmitter, verify that you've selected the correct channel and then repeat the move command. Also, ensure you press the button long enough and reduce any distance to Wisotronic. If a safety function is active, wait until the cause (precipitation, wind, ice) is no longer present, or reset the wind test if it identified a fault.
Why is the sun shading lowering too late in sunshine with my WAREMA Control Systems?
If the sun shading is lowered too late in the sunshine with your WAREMA Control Systems, the "Delay LOW" limit value may be set too high (sun control). Change the limit value.
What to do if the ice alarm is not triggered on my WAREMA Wisotronic?
If the ice alarm on your WAREMA Control Systems is not triggered, first ensure that ice monitoring is switched on. Next, check if the temperature limit value is set too low and change the limit value, noting the safety instructions. Also, verify that the sensor is properly connected, not faulty, and clean.
Why aren't the comfort functions working as expected on my WAREMA Control Systems?
If the comfort functions for dawn/dusk, sun, and temperature control are not functioning as desired on your WAREMA Control Systems, first check if the control timer is switched off. If so, switch on the control timer or change the programming. Alternatively, the control timer might not be correctly programmed, so change the programming of the control timer.
General| Brand | WAREMA |
|---|---|
| Model | Wisotronic |
| Category | Control Systems |
| Language | English |
To Next Page
