EasyManua.ls Logo

Waring MX1000XT - Grounding Instructions; Blender Specifications

Waring MX1000XT
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GROUNDING INSTRUCTIONS
For your protection, this appliance is equipped with a 3-conductor cord set.
120 Volt units are supplied with a molded 3-prong grounding-type plug
(NEMA 5-15P) and should be used in combination with a properly connected
grounding-type outlet as shown in Figure A.
If a grounding-type outlet is not available, an adapter, as shown in Figure B,
may be used to enable a 2-slot wall outlet to be used with a 3-prong plug.*
As shown in Figure C, the adapter must be grounded by attaching its
grounding lug under the screw of the outlet cover plate.
Caution: Before using an adapter, it must be determined that the outlet
cover plate screw is properly grounded. If in doubt, consult a licensed
electrician.
Never use an adapter unless you are sure it is properly grounded.
NOTE:
Use of an adapter is not permitted in Canada and Europe.
Green/Yellow: Earth Ground. Blue: Neutral. Brown: Live.
MX1000XT, MX1050XT, MX1100XT
BLENDER
SPECIFICATIONS
Capacity: 64 oz Working Capacity
(48 oz capacity MX1000XTP,
MX1050XTP, MX1100XTP)
Switch Settings: (2 speeds) Hi Low Pulse
Speed (RPMs) 30,000 26,000 30,000
Rating: 120 Volts - 13.0 Amps
Base Material: Polycarbonate
Bearing: High Precision Ball Bearing
Cord: 6-Foot Three-Conductor Ground Cord with Strain Relief in Base
Overall Height: 19 Inches
Weight: 15 lbs
C
ETL
US
, NSF listed
Operating Cycle: 1 min. O
N
/
3 min. OFF
MX1100XT 30-Second Countdown Timer
3

Related product manuals