7. Set the control switch to low speed and mix for
3 seconds. If your recipe requires high speed, switch
to high speed after mixing 3 seconds on low speed;
otherwise, continue on low speed until finished.
8. When mixing is complete, always set the control switch
to “OFF” (O) before removing the mixing cup.
Operating Cycle: 3 min. ON/1 min. OFF
CLEANING
1. Not for water jet cleaning.
2. Clean the drink mixer before initial use, and immediately
after each use.
3. Clean the spindle, agitator, and mixing cup by filling the
mixing cup to the top fill mark with warm soapy water.
Attach the mixing cup to the drink mixer and run it on
Low speed for about 30 seconds. Turn the unit “OFF”
(O), empty the mixing cup, and repeat with rinse water.
Turn the unit “OFF” (O) again, empty the mixing cup,
and allow it to dry.
4
To Next Page
Loading...
Need help?
General
