13
CLEANING & MAINTENANCE
1. Always unplug appliance, detach the breakaway cord,
and let the oil cool down to room temperature before
cleaning.
2. Raise control panel/heater assembly and allow oil or water to
drain into the reservoir.
3. The control panel should never be immersed in water
or other liquids. Clean the outer surface of the heating
element with a damp cloth containing mild soap solution
or clean water.
Tip: For easy cleaning, wipe control panel with a damp
microber cloth. Microber cloths are available in most
kitchenware stores.
4. Carefully remove oil or water using the draining spigot
located on the bottom of the front housing. Place a container
underneath the spigot, attach the drain hose and turn
counterclockwise until the liquid is fully drained. Then, turn
the spigot clockwise until it is fully closed.
5. The basket, lid, rotisserie and reservoir must be hand washed
with warm soapy water. PARTS ARE NOT DISHWASHER
SAFE.
6. The housing is submersible and should be washed by hand
with warm soapy water.
7. Ensure that ALL PARTS are completely dry after washing and
before use.
8. After cleaning, reassemble reservoir, heating element, basket,
and lid. The heating element must be attached properly to
the back of the housing or a safety feature will prevent the
unit from operating.
Any other servicing should be performed by an authorized service
representative.
To Next Page
Loading...
Need help?
General
