7
ASSEMBLING YOUR WARING
®
COMMERCIAL
JUICE EXTRACTOR
For your safety, the juice extractor will not operate until the machine
is properly assembled. To assemble this unit, the following steps
must be followed in the order given.
Step 1
Place juice bowl on top of the motor housing.
Step 2
Place the stainless steel lter basket inside the center of the
juice bowl. Make sure it slides into place by pressing rmly and
spinning until it locks into place. To avoid injury, do not press on
shredder disc.
Step 3
Place the top cover onto the housing by aligning the tabs on both
sides. If cover does not t, this means that the lter basket is not
properly seated onto the juice bowl.
Step 4
Lock the top cover into place with the locking arm by lifting arm up
so that it snaps the lid down onto the juicing assembly.
Step 5
Place the pulp container into place to the right of the housing by
sliding it under the top cover. Tilt and push bottom of pulp container
into unit until it is seated properly. NOTE: Unit will not operate if top
cover and pulp container are not properly positioned.
OPERATING INSTRUCTIONS
NOTE: The juice extractor will not operate until the top cover and
pulp container are locked into position.
Step 1
Wash your fruit and vegetables for juicing. NOTE: Most fruit and
vegetables such as apples, carrots and cucumbers will not need to
be cut to size, as they will t into the feed chute whole.
Step 2
Ensure that the juice extractor is correctly assembled and that a juice
collector cup is placed under the spout while juicing.
To Next Page
Loading...
Need help?
General
