10
SETTING THE CLOCK
1. To set the clock, press and hold the button for
2 seconds.
2. Use the
arrows to scroll.
3. Once the desired time is displayed, wait 10 seconds, and the
time will be set. Display will show set time for 3 seconds.
WATER SOURCE
Autofill Mode
1. When in autoll mode, auto ll icon ashes while unit is lling
with water.
2. The heater will start when water level reaches low-level sensor.
Note: if water does not reach the low-level sensor within 5
minutes, error code 6 ashes on screen. See troubleshooting
section for details.
3. When water reaches temperature, unit will display READY along
with the set temperature.
Manual Mode
You must change the setting on the hot water dispenser to manual
mode if you wish to ll water manually. This will prevent the unit from
thinking water will automatically ll.
Press Autoll/manual mode to toggle to manual mode.
To ll manually:
1. Remove the lid and ll with water.
2. While lling, the manual mode icon will ash until the minimum
water level is reached. Once the max ll (10 gal) is reached, the
icon will go off.
3. When water reaches temperature, unit will display READY along
with the set temperature.
NIGHT MODE
In Night Mode, unit will maintain water temperature at 158°F/70°C
during non-business hours to save energy and enable a quicker
heat up time, so that hot water is ready when you need it. When
setting the time for night mode, you will be setting the time the unit
will be re-energized and will start heating the water to your pre-set
temperature. (i.e. 5:00 am – unit will turn back on and starts heating
to 205°F).
To Next Page
Loading...
Need help?
General
