7
DIGITAL DISPLAY & CONTROLS
Standby – turns power on and
off to the controls.
Temp/Time – Press to set the
temperature. Press and hold to
set time.
Arrows – use to adjust settings.
Auto Fill/Manual – toggles between
auto ll/plumbed in and manual
ll/pour-over.
Start – press to start the heater.
Night Mode – Press to activate
night mode.
Light Bulb – Press to illuminate
the display.
UNPACKING & INSTALLATION
CAUTION: This is a heavy piece of equipment. It is recommended
that moving or lifting the unit be done by two people to avoid injury.
Carefully unpack the machine and make sure there was no damage
during shipping. Contact customer service if you notice any issues.
NOTE: The person installing the appliance is responsible for
ensuring that electric and water connections meet the requirements
of the national electric code, national plumbing code, and any local
ordinances.
INSTALLATION
1. Find a location near a water connection if the machine will be
plumbed in.
2. Remove the hot water dispenser from the packing material.
The overow tray and four legs are packed separately.
3. Install legs by laying hot water dispenser on its side and
screwing legs into leg supports until tight.
4. Carefully stand up the hot water dispenser and place it on a at,
AUTO FILL
NIGHT MODE
MANUAL FILL
HEATING
DIGITAL DISPLAY ICONS
To Next Page
Loading...
Need help?
General
