4
• Night Mode feature conserves energy and ensures hot water
is ready when you need.
• Fill rate: approximately 1 gallon per minute when unit is
plumbed-in
• Initial heat-up time to full capacity: approximately 3 hours
(assuming water is at 75°F (23°C) to start)
• Temperature range from 150˚F–205˚F (65˚C–96˚C)
• Hot water dispenser will maintain set water temperature
within +/- 5°F
• Safety Features
• Tomlinson
®
No-Drip
®
tap operation*
• Excess water drain: Easily and safely removes excess water
from below spigot level.
• Knuckle guard: Protects hand from hot surface.
• Low water level sensor: In case water level gets low, an
alarm will sound and the heater will automatically be shut off.
This protects your machine. Once the issue is corrected/more
water added, the alarm will stop.
• High-level water sensor: If water level gets too high, an alarm
will sound and the heater will automatically be shut off.
GROUNDING INSTRUCTIONS
For your protection, the Waring
TM
Commercial Hot Water Dispenser
is equipped with a 3-conductor cord set that has a molded 3-prong
grounding-type plug, and should be used in combination with a
properly connected grounding-type outlet as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained so that a 2-slot wall outlet can be used
with a 3-prong plug. Referring to Figure 3, the adapter must be
grounded by attaching its grounding lug under the screw of the
outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician. Never use an adapter unless you are sure it is
properly grounded.
NOTE: Use of an adapter is not permitted in Canada.
* Tomlinson
®
, No-Drip
®
and the Faucet and Handle configurations are registered trademarks of The Meyer Company, Cleveland, Ohio.
To Next Page
Loading...
Need help?
General
