Need help?Do you have a question about the Warm Audio WA-2A and is the answer not in the manual?
Information on obtaining service for units outside of warranty conditions.
Selects between compressor and limiter modes, affecting the ratio.
Adjusts the amount of makeup gain applied to the output signal.
Details impedance and pinout for balanced inputs and outputs.
Defines frequency response, gain, peak reduction, and level limits.
Specifies THD, noise floor, attack, and release times.
Lists tube compliment, optical attenuator, power, and fuse information.
Lists compatible vacuum tubes for substitution and important warnings.
Important safety warnings regarding service and modification of the unit.
Information on obtaining service for units outside of warranty conditions.
Selects between compressor and limiter modes, affecting the ratio.
Adjusts the amount of makeup gain applied to the output signal.
Details impedance and pinout for balanced inputs and outputs.
Defines frequency response, gain, peak reduction, and level limits.
Specifies THD, noise floor, attack, and release times.
Lists tube compliment, optical attenuator, power, and fuse information.
Lists compatible vacuum tubes for substitution and important warnings.
Important safety warnings regarding service and modification of the unit.
General| Output gain | 40 dB |
|---|---|
| Product type | Compressor & gate |
| Frequency range | 15 - 20000 Hz |
| Compressor attack time | 10 ms |
| Compressor release time | 0.5 - 5 ms |
| Total Harmonic Distortion (THD) + noise | 0.1 % |
| On/off switch | Yes |
| Product color | Gray |
| Rack capacity | 2U |
| Housing material | Steel |
| AC input voltage | 115/230 V |
| AC input frequency | 50/60 Hz |
Weight and Dimensions| Depth | 177.8 mm |
|---|---|
| Width | 482.6 mm |
| Height | 88.9 mm |
| Weight | 5443 g |
To Next Page
