WarmPool DC55 - Your heat pump and your pool pump must be installed close to each other.; Your heat pump must be placed outdoors and must follow the minimum spacings shown on the connection diagram.; Your heat pump should be level and at least 15 cm above the ground. We recommend you use blocks and drain the condensation into a sump (which can be covered with gravel).; If any of these recommendations are not followed or are not applicable, please contact the manufacturer to make sure that the installation performed or to be performed will not affect the proper functioning of your heat pump.

~ 5 ~
Installation and operation manual DC
2.5 Dimension of swimming pool heat pump DC 115
3. Installation and connections
3.1 Installation
Your heat pump and your pool pump must be installed close to each other.
Your heat pump must be placed outdoors and must follow the minimum spacings
shown on the connection diagram.
Your heat pump should be level and at least 15 cm above the ground. We recommend
you use blocks and drain the condensation into a sump (which can be covered with
gravel).
If any of these recommendations are not followed or are not applicable, please contact
the manufacturer to make sure that the installation performed or to be performed will
not affect the proper functioning of your heat pump.
Using your heat pump will necessarily create condensation (up to several liters of
water per hour). This is not a leak.