WARMTECH WT01 Instructions warmtech.com.au | 12
Voltage 100-240 VAC
Max. pre-fuse 16 A
Built-in circuit breaker 2-pole, 16 A
Output relay make contact - SPST - NO
Output max. 16 A
Terminal wire size 1.5-2.5 mm2
Control principle PWM/PI
Standby power 0.5 W
Battery backup 5 years
Action type 1.B
Software class A
TB 125°C
ELV limits realized SELV 24 V
Pollution degree rating 2
Rated impulse voltage 4 kV
Enclosure rating IP 21
Dimensions H/115, W/84, D/40 mm
Build-in depth 23 mm
Display 176x220 pixel TFT - resistive touch
EU registered design DM/082270
Twelve (12) Month Warranty
This product is warranted against defects in material and workmanship under normal conditions of use for a period
of twelve months from the date of purchase. During this period, Warmtech will repair or replace the product, if it
is defective in normal operating conditions in terms of materials or workmanship, with a new product of equivalent
quality at Warmtech’s option. The warranty does not cover costs of transportation, removal, installation or damage
caused by misuse or accident. In no event will Warmtech be liable for consequential loss resulting from the installation
of the product.
Any defective product should be sent with the original invoice to the original installer, or shipped prepaid, insured
and sent to Warmtech.
Customer Assistance
Phone: 1300 138 126
Email: info@warmtech.com.au
Website: www.warmtech.com.au
The thermostat is maintenance free.
WARRANTY
TECHNICAL DATA
To Previous Page
Loading...