WARMTECH WT01 Instructions warmtech.com.au | 11
FIG. 9 – TROUBLESHOOTING
If the sensor is disconnected or short-circuited, the heating system is switched off. The sensor can be checked against
the resistance table.
Error codes
E0: Internal fault. The thermostat must be replaced.
E1: Built-in sensor defective or short-circuited. Replace the thermostat, or use the floor sensor only.
E2: External sensor disconnected, defective or short-circuited. Reconnect the sensor if disconnected,
or replace the sensor.
E5: Internal overheating. Inspect the installation.
CE marking
According to the following standard: LVD/EMC: EN 60730-2-9
Classification
Protection from electric shock must be assured by appropriate installation. Appropriate installation must meet the
requirements of Class II (enhanced insulation).
Environment and recycling
Please help us to protect the environment by disposing of the packaging in accordance with national regulations for
waste processing.
Recycling of obsolete appliances
Appliances with this label must not be disposed
of with general household waste. They must
be collected separately and disposed of in
compliance with local regulations.
To Next Page
Loading...