WARN INDUSTRIES PAGE 2 80546A1
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
I. TABLE OF CONTENTS
Tools Required page 2
Parts List page 3
Installation page 4-6
Polaris Winch Mount page 4
WARN Winch Mount page 5-7
Maintenance/Care page 7
CAUTION
Moving Parts Entanglement Hazard
Failure to observe these instructions could lead to minor or moderate injury.
Always take time to fully read and understand the installation and Operations Guide included with this product.
Never operate this product if you are under 16 years of age.
Never operate this product when under the influence of drugs, alcohol or medications.
Read installation and operating instructions thoroughly.
NOTICE
Equipment Damage
Always refer to the Installation and Specification Guide, supplied in the winch kit, for all wiring schematics and specific details on how
to wire this WARN product to your vehicle.
Never overtighten the j-bolt to the bracket. Doing so will pinch the winch cable against the bracket, damaging the cable.
Always put the end of the actuator cable through the slot in the Termination Bracket. Terminating the cable through any other hole in the
bracket will cause the bracket to not function properly and will drastically reduce the life of the actuator cable.
Read installation and operating instructions thoroughly.
II. TOOLS REQUIRED
- 3/8" Rachet with 3-1/2" extension
- Sockets: 10mm, 13mm, 16mm
- Wrenches: 13mm, 16mm, 17mm
To Next Page
Loading...