17
MAINTENANCE CHART
Item Remark Pre-operation Initial 1 month Every 3 month Every 6 month Every 12 month
check (daily) or 20hours or 50 hours or 100 hours or 300 hours
Spark plug Check condition
Adjust gap and clean
Replace if required
Engine oil Check oil level
Replace
Air filter Clean. replace if required
Fuel Filter Clean fuel cock filter
Replace if required
Valve Check and adjust when
clearance engine is cold
Fuel line Check fuel hose for cracks
or damage. Replace if required
Exhaust Check for leakage. Tighten or
system replace gasket if required.
Check exhaust screen. Clean
and replace if required.
Carburetor Check choke operation
Cooling Check fan damage
system
Starting Check recoil starter
system operation
Decarbon- More frequently
isation if necessary
Fittings/ Check all fittings and fixtures
Fastenings and tighten if required
The figures quoted are emission levels and are
not necessarily safe working levels. Whilst there
is a correlation between the emission and
exposure levels, this cannot be used reliably to
determine whether or not the actual level of
exposure of the workroom, the other sources of
noise etc. i.e. the number of machines and the
adjacent processes and the length of time for
which an operator is exposed to the noise. Also
the permissible exposure level can vary from
country. This information however, will enable the
user of the machine to make a better evaluation
of the hazard and risk. The supplier
recommends the use of ear protection at all
time.
To Next Page
Loading...
