Washtech CD120 - Operator Troubleshooting

4/26/2022 13
Operator Troubleshooting
Issue Cause
POOR
PRE-SCRAPING
CARRY OVER OF SOAP FROM SINK OVERLOADING
RACKS
POOR
MACHINE CARE
JETS BLOCKED OR ARMS OBSTRUCTED CURTAINS NOT FITTED CORRECTLY WATER SUPPLY PRESSURE LOW POOR WATER
QUALITY**
RINSE TEMPERATURE LOW <75˚C PAWL DRIVE NOT OPERATING CRASHING
SOUND AGAINST DOOR
DISHES NOT CLEAN
      
STAINING
    
FOAMING
 
PROTEIN BLOOM
     
DIRTY MACHINE
     
FOOD RESIDUE ON WARE
      
FILM/SPOTS ON WARE
     
DETERGENT RESIDUE
  
GREASY FILM/NO FIZZ
  
WET WASHWARE
  
SCALE BUILD UP IN MACHINE
 
FILTERS ON OTHER EQUIPMENT

LIMIT SWITCH ACTIVATED

WASH ARM NOT FITTED PROPERLY

MACHINE STOPS & REFILLS CONSTANTLY

 Likely cause  Possible cause
* For issues most likely due to incorrect chemical dosages or other chemical issues, we
recommend you consult your chemical supplier and/or a local chemical expert prior to calling
in a dishwasher technician.
** For issues that are likely due to poor water quality (scale building up, filters being required
on other kitchen equipment etc.), we recommend you consult a local water specialist prior to
calling in a dishwasher technician.
IF PROBLEMS PERSIST CONTACT MOFFAT SERVICE ON 1300 264 217
Washtech CD120L Operator Manual