Specifying Report Sections
User Guide 239
3 From the Time Span drop-down list, select the time
you want the report to cover.
If you chose anything but Specify Time Filters, click OK.
If you chose Specify Time Filters, click the Start and End drop-
down lists and select a start time and end time, respectively.
4 Click OK.
Specifying Report Sections
Use the Sections tab on the Report Properties dialog box
to specify the type of information you want to be included
in reports. From Historical Reports:
1 Click the Sections tab.
2 Select the checkboxes for sections to be included in the
report.
For a description of each section, see “Report Sections and
Consolidated Sections” on page 246.
3 To run authentication resolution on IP addresses, select
the checkbox marked Authentication Resolution on IP
addresses.
If user authentication is not enabled, you will not have the
information in your logs to perform authentication resolution on
IP addresses. However, generating a report when resolution is
enabled will take considerably more time.
4 To run DNS resolution on IP addresses, select the
checkbox marked DNS Resolution on IP addresses.
Consolidating Report Sections
The Sections tab defines the types of information to be
included in a report on each of a group of Fireboxes: a ver-
tical look at the data. You can also specify parameters that
consolidate information for a group of Fireboxes: a hori-
To Next Page
Loading...
