To Next PageTo Next Page
Need help?Do you have a question about the Water I.D. Water Tester and is the answer not in the manual?
General| Accuracy (TDS) | ±2% |
|---|---|
| Display | LCD |
| Temperature Accuracy | ±0.5 °C |
| Automatic Temperature Compensation | Yes |
| Parameters Measured | TDS, Temperature |
Information menu for cloud synchronization setup.
Information menu for WiFi connection setup.
Adjust time format (12h/24h) and auto-correction.
Adjust date format (MM/DD/YYYY or DD/MM/YYYY).
Select reagent mode (tablet or liquid).
Create and transfer sampling points via LabCOM app.
Adjust screen brightness, affecting power consumption.
Instructions on when and how to perform calibration.
Specifies measurement chamber usage for single or chamber 2.
Advice on using different colored stirring rods to prevent contamination.
Use PHOTOMETER grade tablets, not RAPID grade.
Advice on date, cuvette, humidity, and cleaning.
Avoid sun exposure and note suitability for saltwater pools.
Step-by-step guide for single parameter measurement.
Step-by-step guide for multiple parameter measurement.
Step-by-step guide for performing the ZERO measurement.
