Water Tech POOL BLASTER CATFISH PPV - Product Specs and Parts; Product Specifications; Parts and Accessories

CONGRATULATIONS on your purchase of a top-quality Water Tech product, which has been
thoroughly tested to meet our exacting quality control standards.
State of the art Nickel-Metal Hydride batteries power the cleaner. These are the same bat
-
teries used in many portable phones. In order to properly ventilate and cool the batteries
and drive system, a certain amount of space is left open in the cleaner body. As a result,
from time to time, water may enter the unit. In order to allow for any water to be drained
you should remove the battery cap after each use, and stand it on its end until the excess
water is drained. The amount of water may be very small or not noticed at all. After remov
-
ing any water use a blow dryer on warm setting to dry any moisture build-up on the inside
of the motor box. Water entering the cleaner body presents no safety hazard and should
be drained occasionally to avoid any chance of long-term corrosion. The batteries and
motor in the cleaner are long lasting and proper care will help to prolong the life of your
appliance.
These guidelines and safeguards help insure that your new cleaner operates effectively.
Please read all instructions carefully before using your cleaner. Please take a few moments
to review the following IMPORTANT INFORMATION before using this tool.
Product Specifications
HANDVAC BATTERY
Motor 7.2 Volt, DC Charger Rating 120V, 60 Hz AC only (US)
240 volts. 50Hz AC only (International)
Switch On-Off Charger Voltage 8.4 Volt
ITEM No. DESCRIPTION PART No. QTY.
1 Vacuum Head PBA006 1
2 Vacuum Head Brushes (for vinyl pools) PBW049 8
3 Vacuum Head Wheels (for gunite pools) PBW050 5
4 Nose Cap PBA002 1
5 All Purpose Filter Bag/Seal Ring PBW022AP 1
6 cleaner PBA005 1
7 Battery Charger PBA099* 1
8 Spring Clip PBW041 1
ADDITIONAL PARTS:
- Sand & Silt bag (part No. PBW022SS)
- Microfilter Bag (part No. PBW022MF), to be used in conjunction wih Sand & Silt bag
- Shallow Water Hose Attachment (part No. PBASHA)
* U.S. Charger (part No. PBA099)
* UK 230V Charger (part No. WT3843)
To purchase parts, go to www.poolbuster.com contact your retailer or call us at (800)298-8800
VAC HEAD
NOSE CAP
HANDLE/ POOL POLE
ATTACHMENT
BATTERY CAP