To Next Page
M
Maria HernandezSep 10, 2025
Why does my WaterBoss 900 indicate flow when no water is being used?
- TTeresa DukeSep 10, 2025
This usually means the household plumbing system has a leak. Repair the leak to resolve the issue.
Why does my WaterBoss 900 indicate flow when no water is being used?
This usually means the household plumbing system has a leak. Repair the leak to resolve the issue.
Why is my WaterBoss 900 Water Dispenser dispensing salty water?
Several factors can lead to salty water. Here's what to check: * Plugged injector: Replace the injector screen, nozzle, and throat. * Low water pressure: Maintain a minimum pressure of 20 psi. * Restricted drain line or flow control: Remove any restrictions. * Restricted or crimped brine line: Remove any restrictions; replace the line if crimped. * Excessive water in brine cabinet: Verify the correct water level relative to the salt setting and check lines and fittings for loose connections. * Intermittent pressure drop: Install a check valve on the inlet water line to the appliance (check local plumbing codes first). * Brine valve drips water back to brine cabinet: Clean the brine valve housing and replace the piston assembly.
Why is there no read-out in the display of my WaterBoss 900?
Check the following: * Make sure the electric cord is plugged in. * Verify there is electric power at the outlet and ensure the outlet is not controlled by a switch. * Test the transformer with a volt meter for 12 VAC at the control. If it's less than 10 VAC or greater than 14 VAC, replace the transformer. * With 12 VAC present at the controller, replace the controller if there's still no display. * Note that high ambient room temperature can cause this, but no action is necessary.
General| Brand | WaterBoss |
|---|---|
| Model | 900 |
| Category | Water Dispenser |
| Language | English |
Details what the warranty covers, its duration, and specific exclusions.
Outlines the steps and information required to submit a warranty claim.
Provides contact details and a section for recording owner-specific data.
Offers guidance for optimal performance and presents product efficiency statements.
Lists critical checks for water quality, hardness, pressure, and flow.
Key guidelines and warnings to follow during the installation process.
Steps for preparing the appliance's installation location.
Procedure for testing water quality before connecting the appliance.
Instructions for safely shutting off the main water supply.
Guidance on connecting inlet, outlet, drain, and overflow lines.
How to properly connect the overflow drain line.
Instructions for connecting the main drain line for backwash water.
Procedures for flushing the system and verifying leak-free connections.
Steps to identify and repair any leaks after installation.
How to connect the appliance's power supply.
Initial programming of the controller settings.
Instructions for filling the brine cabinet with the initial water amount.
Guide on adding salt to the brine cabinet.
Final steps to finalize the appliance installation and startup.
Explains how to engage and disengage the bypass for various functions.
Overview of the controller's display, buttons, and their operations.
Guide to finding and entering water hardness settings.
Covers setting operational modes, regeneration schedules, and units.
Guidelines for plumbing with copper fittings and PVC/CPVC pipes.
Identifies major external parts of the appliance cabinet and covers.
Details assemblies like injector, bypass, drive end cap, and brine valve housings.
Details the safety shutoff assembly and its installation connections.
Solutions for issues like no soft water, flow errors, and display problems.
Addresses problems with regeneration sequence, salty water, and controller error codes.
Lists compliance certificates and provides general notes for the user.
