To Next PageTo Next Page
Need help?Do you have a question about the Waterco ElectroHeat MKIV and is the answer not in the manual?
Record model and serial number for warranty and service reference.
Describes the optimal placement for the pool heat pump unit.
Specifies required space around the unit for air circulation and service.
Details the recommended plumbing layout and connection procedures.
Defines the optimal water flow for efficient heat transfer.
Explains the necessity and function of a bypass kit.
Covers electrical connection requirements and safety precautions.
Outlines crucial steps for electrical safety through bonding.
Instructions for connecting external controls to the heat pump.
Guidelines for maintaining water quality and chemical levels.
Process for achieving the desired pool water temperature initially.
Guidance on optimal operating hours for the heat pump.
Recommends using a solar blanket to minimize heat loss.
Explains the automatic defrost process and its triggers.
Procedure to ensure accurate temperature readings from the unit.
Instructions for switching the temperature display unit.
Specific defrost information for certain models.
Details internal safety controls protecting the unit.
Refers to error codes and their meanings.
Overview of different controller types and their features.
Step-by-step guide to initiating the heat pump operation.
Simple instructions to turn off the heat pump.
Explanation of button functions and interface controls.
Details on setting and using the unit's timer functions.
Describes the controller display and button functions.
Explains the function of the unit's buzzer.
Describes how the controller retains settings.
Instructions for cleaning the exterior casing of the unit.
Guidance on cleaning the evaporator for optimal performance.
Instructions to keep condensate drain holes clear.
Specific maintenance for units in coastal environments.
Essential steps for preparing the unit for winter to prevent damage.
Troubleshooting steps when the unit has no power or response.
Addresses issues where the control panel shows data but unit is non-operational.
Steps to diagnose why the fan motor is not running.
Troubleshooting when the fan operates but the compressor does not.
Diagnosing frequent compressor cycling or immediate shutdown.
Differentiating condensation from leaks and troubleshooting.
Steps to take when ice forms on the evaporator.
Troubleshooting why the unit fails to heat the pool to the set temperature.
A chart for recording operational data to diagnose performance issues.
Reasons for circuit breaker tripping and how to address it.
Identifying and resolving unusual noises from the unit.
Addresses discrepancies between unit and external thermometer readings.
Explains error codes displayed by the standard electronic control.
Troubleshooting specific defrost-related error codes.
Diagnosing issues related to low refrigerant or pressure controls.
Troubleshooting problems with high pressure or circulation.
Addresses issues where the unit is set to OFF or the control is defective.
Diagnosing problems with water temperature probes.
Explains the 'ot' code for high internal water temperature.
Lists and explains error codes for inverter models.
General| Brand | Waterco |
|---|---|
| Model | ElectroHeat MKIV |
| Category | Swimming Pool Heater |
| Language | English |
