NOTE：
1. Feed water temperature should not be above 100°F(38°C).
2. Pressure mini water tank has already been filled with sufficient gas during
manufacture process.You don't need to fill gas before normal use.
3. After connecting the machine to the distribution valve, the water flow rate from the
faucet will decrease, which is normal.
Frequently asked questions:
Q: What should I do if water in the water tank doesn't come out?
A: Please check if the internal membrane breaks. Unscrew off the stem and you will see
a protruding charging valve, and then press the charging valve. If water flows out, it
indicates the internal membrane breaks. Please change a new water tank. If no water
flows out, please contact customer service.
Q: What should I do if there is a leakage?
A: (a) Quick-fitting leakage: after installation, please confirm if PE piput smoothly. If not,
cut the tubing squarely and cleanly. Make sure the tubing is fully inserted.
(b) Leakage between ball valve and the tank: please check if there its a washer
connecting the ball valve, if not, please contact us for a new ball valve.
Q: Where should I connect the pressure mini tank to if the RO system has been
connected with an MNR filter and an UV sterilizer.
A: It is recommended to c
onnect these components in a sequence as follows:
RO system-->Pressure mini water tank->MNR filter-->UV sterilizer-Refrigerator.
California Residents
“ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov”
EPA Est. No. 95301-CHN-1 Made in China V003
To Next Page
Loading...