WaterGroup E75TFC-3 - User Manual

Questions and Answers

B
Brandon ShepardAug 1, 2025
What to do if there is no water or not enough water from my WaterGroup Water System?
- H
  Heidi CookAug 1, 2025
  If you're experiencing no water or not enough water from your WaterGroup Water System, there are several potential causes: * The feed water might be shut off. Ensure it is turned on. * The storage tank valve could be closed. Make sure it's open. * Lines may be plugged or crimped. Remove any blockages or crimps. * The pre-filter cartridge might be clogged. Replace it. * Feed water pressure might be low. The pressure at the membrane must be at least 50 psi.
T
Timothy MooreAug 7, 2025
Why is the product water TDS high in my WaterGroup Water System?
- S
  Sherry MccormickAug 7, 2025
  If you notice a high TDS (Total Dissolved Solids) in your WaterGroup Water System's product water, here's what might be happening and how to address it: * The filters may not be sufficiently flushed. To resolve this, draw approximately 5 gallons (about 2 full tanks) from the spigot to properly flush the filters. * There could be an increase in the feed water TDS. Contact your dealer to discuss the revised product water TDS. * The membrane life might be expired. If this is the case, replace the membrane.
A
Allison ReynoldsAug 12, 2025
How to fix low flow rate from the faucet of WaterGroup E75TFC-3?
- B
  bwhiteAug 12, 2025
  If you're experiencing a low flow rate from the faucet of your WaterGroup Water System, here's what could be causing it: * Low air pressure in the storage tank. Increase the air pressure to 7 psi after draining the product water from the storage tank. * The storage tank valve is partially closed. Open the tank valve completely.
B
Brandon BaldwinAug 18, 2025
Why does my WaterGroup E75TFC-3 water taste bad?
- J
  Joseph MartinAug 19, 2025
  If your WaterGroup Water System is producing bad tasting water, consider the following: * The taste might be coming from glass or plastic containers. Contact your dealer for an explanation. * The post carbon filter cartridge may be exhausted. Replace the post carbon filter cartridge. * The storage tank and/or system may be contaminated. Contact your dealer for assistance. * The membrane life might be expired. Replace the membrane.
S
Sarah PrestonAug 25, 2025
What to do if my WaterGroup E75TFC-3 makes cloudy ice cubes?
- D
  Daniel GuerraAug 26, 2025
  Cloudy ice cubes from your WaterGroup Water System can be attributed to: * Cloudy water. See the troubleshooting steps for cloudy water. * Certain ice cube shapes trapping dissolved air. Larger, more squared-off cubes tend to be clearer, while smaller, rounded cubes are cloudier. Try changing the ice cube mold shape, making cubes manually if using an automatic ice cube maker, and letting the water stand to release dissolved air before freezing.