6
GETTING STARTED WITH YOUR WATER FLOSSER
Fill
High
Low
Push
Power
ON/OFF
Push
Power
ON/OFF
Water
ON
Water
ON
Insert
Slide
to
Eject
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be
sure it is turned on.
Preparing the Reservoir
Li the reservoir lid, remove the reservoir, and ll with lukewarm water. Replace the
reservoir over the base and press down rmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down rmly until tip
clicks into place. The colored ring will be ush with the top of the handle if the tip is
correctly locked into place.
To remove tip from the handle, slide the tip eject button on the handle.
Caution: Do not use tip eject slide while unit is running.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point the handle
and tip into sink. PUSH power button ON. Switch water switch to ON until water
ows from the tip. Switch water to OFF and PUSH power OFF.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting (pressure
setting No. 1) for rst-time use. Gradually increase pressure over time to the setting
you prefer – or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the water ON. With water
switch in OFF position, PUSH power on. Lean over sink and slightly close lips
enough to prevent splashing while still allowing water to ow from mouth
into the sink. Turn water switch ON. When nished, turn water switch and
power OFF. During use you can stop the ow of water by sliding the water switch
on handle to the OFF position.
NOTE: Motor will continue to run.
To Next Page
Loading...
