Waterpik Water Flosser WP-450 User Manual

Insert
I
I
II
O
1
Model WP-450/462
This device is compatible with a voltage system of 240VAC, 50Hz.
FIRST USE
Charge unit for 24
hours by inserting the
charging cord into
unit.
Insert tip firmly
until it clicks
into place.
Fill reservoir with
warm water.
QUICK START GUIDE
Review full instruction book prior to first use
©2016 Water Pik, Inc.

Waterpik Water Flosser WP-450 Specifications

General

Model Number	WP-450
Type	Cordless Water Flosser
Pressure Range	45 to 75 PSI
Pulses per Minute	1450
Battery Type	NiMH
Number of Tips Included	4
Tip Rotation	360 degrees
Waterproof	Yes
Pressure Settings	2
Rechargeable	Yes
Reservoir Capacity	7 oz

Summary

First Use

Charge the Unit

Charge unit for 24 hours by inserting the charging cord into unit.

Insert Water Flosser Tip

Insert tip firmly until it clicks into place.

Fill Reservoir

Fill reservoir with warm water.

Start Water Flossing

Mouth Preparation

Place tip in mouth before turning unit on to avoid mess.

Pressure Adjustment

Adjust pressure to LOW (I) or HI (II) setting for desired water pressure.

Lean Over Sink

Water Flow Management

Close lips to prevent splashing, while allowing water to flow into the sink.

Flossing Technique

Gumline Targeting

Aim water at the gumline at a 90° angle, pausing briefly between teeth.