human proximity to the antenna must be at least 10 cm during normal operation, and the antenna
must not be co-located or operating in conjunction with any other antenna or transmitter.
1.5.2 Near field communications (NFC)/RFID aspects
The Alliance iS Column Heater Cooler (CHC) is used with the Alliance iS HPLC System. The
CHC can be equipped with NFC/RFID technology. The national approvals associated with this
RF feature are associated only with the CHC and not with other sections of the system or the
system in its entirety. The 13.56-MHz NFC/RFID reader is located on the door of the CHC. It
performs a read cycle when the door is closed. The duration of the read cycle is less than one
second. It is inactive until the next door open/door close event. The power is less than 2 W.
1.5.3 ISM classification: ISM group 1 class A
This classification was assigned in accordance with CISPR 11 Industrial Scientific and Medical
(ISM) instruments requirements.
Group 1 products apply to intentionally generated and/or used conductively coupled radio-
frequency energy that is necessary for the internal functioning of the equipment.
Class A products are suitable for use in all establishments other than residential locations and
those directly connected to a low-voltage power supply network supplying a building for domestic
purposes.
There may be potential difficulties in ensuring electromagnetic compatibility in other environments
due to conducted and radiated disturbances.
This equipment complies with the emission and immunity requirements described in the relevant
parts of IEC/EN 61326: Electrical equipment for measurement, control, and laboratory use —
EMC requirements.
1.5.4 Canada spectrum management emissions notice
This class A digital product apparatus complies with CAN ICES-001 (A).
Cet appareil numérique de la classe A est conforme à la norme NMB-001 (A).
This device contains a license-exempt transmitter that complies with Innovation, Science, and
Economic Development Canada’s license-exempt RSSs. Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
1.5.4.1 ISED RF exposure information
The equipment complies with the ISED RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This transmitter must be installed to provide a separation distance
July 14, 2023, 715008685 Ver. 02
Page 8
To Next Page
