Watersnake GEO-SPOT User Manual

PLEASE NOTE:
Watersnake accepts no liability for personal injury or property damage caused while
fitting this motor accessory. Please wear appropriate protective clothing and eyewear/face
protection. Avoid contacting and/or inhaling fibreglass dust or aluminium shavings.
INSTALLATION
1. Install the sensor unit at a distance of more than 1m from the trolling motor.
Position toward the stern of the boat.
2. The arrow on the cover should point towards the bow of the boat.
3. The axis of the two screw holes should be parallel to the keel of the boat.
4. Install the sensor on a fl at horizontal surface. Do not place on a tilted surface.
5. Ensure that there are no high-current power wires or iron-containing objects within 15cm of the sensor.
6. Stainless steel screws are the best option for fi xing (do not use screws containing iron).
BOW
STERN

Watersnake GEO-SPOT Specifications

General

Motor Type	Electric
GPS	Yes
Voltage	12V
Mount Type	Bow Mount
Steering	Electric
Blade Material	Composite
Control	Wireless Handheld Remote

Summary

INSTALLATION

CONNECTION

Direct Connection

Connects the heading sensor signal cable directly to the trolling motor terminal.

Splitter Cable Connection

Uses a splitter cable for foot pedal and heading sensor connection to the trolling motor.

OPERATIONAL INSTRUCTIONS

Deployment

Ensure helix wire is not wrapped or twisted when lowering the motor into water.

Untwisting Function

Sensor automatically untwists the motor if helix wire rotates over 360 degrees.

Jog Function

Allows precise 1.5-meter movements of the trolling motor via remote control.