13
Start Cleaning
Aim at the pool
Aim the Volt 550Li at the pool (place robot
roughly 3 ft. from the edge of the pool).
For above ground pools, drop the robot in the pool after
selecting your desired settings
Push the ON/OFF button and select your
desired Cleaning Cycle and Cleaning Mode.
When the Volt 550Li is done charging, it’s
important that you DO NOT submerge the
Volt 550Li in water without replacing the
rubber plug covering the charging jack.
Failure to follow this step could damage
your unit.
(After the robot is turned on, you will have 10 seconds to
select your desired Cleaning Mode and Cleaning Cycle
shown on Page 7-8)
To Next Page
Loading...