WaterTech Volt Series - Volt 550 Li Calibration Procedure; Calibration Steps

To Next Page

To Previous Page

Volt 550Li Calibration Procedure

x 5

x 1

Only follow the instructions below if instructed to by Water Tech or the

Troubleshooting / FAQs section.

Make sure that the batteries are FULLY CHARGED and the unit is

OUT OF WATER before calibrating.

Calibration Procedure: Read all instructions before attempting to calibrate robot.

1. Turn ON the robot.

3. The “Floor Only” LED light will ash

rapidly to indicate proper entry.

2. Within 5 seconds of turning the robot ON,

press the “Cleaning Mode” button 5 times.

4. Wait for the “Floor Only” LED to stop

ashing, then press the “Cleaning Mode”

button one time.