Waterworks B5 User Manual (English)

Questions and Answers:

J
joseph05Aug 4, 2025
What to do if my Waterworks Water Dispenser is leaking?
- L
  Laurie SkinnerAug 4, 2025
  If your Waterworks Water Dispenser is leaking, first, check if the appliance is installed in an environment where the temperature changes frequently (above 25 degrees Celsius). If the bottle is leaking, remove it, drain about 2 liters of water via the cold water faucet, and then load a new bottle, inspecting it for damage beforehand. Ensure the faucets are tightly fitted and the drain cap on the back is properly fitted and tightened clockwise. If the leak persists after these steps, discontinue use and contact customer service.
W
Wayne VasquezAug 11, 2025
How to fix hot water faucet if it is not hot on Waterworks Water Dispenser?
- W
  William WeissAug 11, 2025
  If the water from the hot water faucet of your Waterworks Water Dispenser is not hot, first check if the hot water switch is on. If it is, try resetting the appliance by unplugging it and pressing the bimetal reset button with a 20 cm screwdriver. If hot water is still unavailable after 30 minutes, contact customer service. Also, if too much hot water has been consumed, wait until the water becomes hot again.
S
szavalaAug 19, 2025
Why is my Waterworks Water Dispenser making noise?
- S
  Stephanie CainAug 19, 2025
  If your Waterworks Water Dispenser is making noise, ensure it's installed on a level surface and not touching other objects. Note that some noise from the condenser during cooling or the sound of flowing water when the compressor starts or stops is normal and safe.