WATEX Ltd., Latvia, Riga, Ganibu dambis 27 k-5, info@watex.eu, Tel. +371 67381989, www.watex.eu
To immediately start the manual regeneration, press and hold the "REGEN" button for 3 seconds. The system will
immediately begin regeneration. This command cannot be canceled.
When the system starts regeneration, the display will change showing information on the recovery process steps and the
remaining time up to the end of the regeneration step. The system will automatically pass through recovery steps and when the
regeneration is complete, set itself in the water treatment mode.
Operation control
During operation, the normal user display is:
• time of day;
• current flow rate liters per minute
• remaining capacity cubic meters per hour.
Each of these can be viewed by pressing NEXT to scroll through them. When stepping through any programming, if there aren’t
any buttons pressed within 5 minutes, the display returns to a normal user display. Any changes made prior to the 5 minute time
out are incorporated.
To quickly exit any Programming, Installer Settings, and so on, press SET CLOCK. Any changes made prior to the exit are
incorporated.
If desired, regeneration at preset time (default 2:00), press the REGEN button. REGEN TODAY will appear on screen.
If desired, immediate regeneration, press and hold the REGEN button for five seconds until a regeneration begins.
To Next Page
Loading...