START UP
Usually all key operating parameters of the WATEX CMS series filter have already been set at the service center. The only thing
that is planned to set for the first run is the time setting.
Regeneration cycles and capacity programming
Press and hold the “NEXT” button simultaneously and arrow down and hold for 3 seconds.
1) The word "softening" flashes in the upper left corner.
2) Press "NEXT". The first "backwash" and the duration of the cycle appear in minutes. Arrows and is possible to
change the duration of the cycle.
3) Press "NEXT" and the second mode "brine" (brine suction) and cycle duration in minutes are displayed. With arrows
and it is possible to change the duration of the cycle.
4) Press "NEXT". The second "backwash" and the duration of the cycle appear in minutes. Arrows and is
possible to change the duration of the cycle.
5) Press "NEXT" ."rinse" and the duration of the cycle appear in minutes. Arrows and it is possible to change
the duration of the cycle.
6) Press "NEXT" and "fill" (reagent tank refill) and mode duration in minutes are displayed. Arrows and it is
possible to change the duration of the mode.
7) Press "NEXT" to display the capacity of the unit in cubic meters. Use the arrows to change the capacity of the
machine. By pressing "NEXT" the previously set data is automatically saved and the programming progresses to the
next settings. Next, press "NEXT" until the current day is displayed.
Therefore, the setup cycle is closed and all settings are saved.
Rinsing mode duration and volume settings
In some circumstances, there is a need to change the rinse mode duration. To do this, do the following:
Press and hold simultaneously the button “NEXT” and the arrow down for 3 seconds.
1) In the upper left corner flashes the word "filtering".
2) Press “NEXT” and there will appear the first rinsing mode “backwash’’ and duration of the mode in minutes. Duration
of the mode can be changed by arrows and .
3) Press “NEXT” and there will appear the second rinsing mode “brine’’(agent suction in) and duration of the mode in
minutes. Duration of the mode can be changed by arrows and . Press “NEXT”.
Thus, the setting mode is closed and all the settings are saved.
Manual regeneration
Sometimes you need to make regeneration earlier before the system determines that it is necessary; it is usually referred to
as manual regeneration. It is possible that there was a period when the water has been used more than usual, for example, where
there have been more visitors or more linen have been washed.
To initiate a manual regeneration in the set deferred regeneration time press and release REGEN. Then the display will flash
the words "REGEN TODAY", indicating that the system will initiate regeneration before the pre-set regeneration. If you have
pressed the "REGEN" button by mistake, re-pressing the button will cancel the request.
To Next Page
Loading...