EasyManua.ls Logo

Watlow 942 Series - Specifications; Secondary Output (Heat, Cool or None); Auxiliary Outputs; Retransmit Output

Watlow 942 Series
63 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WATLOW Series 942 User's Manual
47
Appendix
Specifications
Secondary Output (Heat, Cool or None)
Solid state relay, Form A 0.5A @ 24VAC min., 264VAC maximum, opto-
isolated, zero cross switching. Off state impedance is 20KΩ minimum for
942A-XBXX-X0000 units, and infinite impedance for 942A-XKXX-X000 units.
Electromechanical relay, Form A, 6A @ 120/240VAC, 6A @ 28VDC,
1/8 hp. @ 120VAC, 125VA @ 120VAC. Off state impedance is 20KΩ min.
Switched DC, Open collector, 500Ω minimum load resistance, 1KΩ load,
9mA minimum, 22mA maximum, non-isolated.
Auxiliary Outputs
Electromechanical relay, Form A (N.O.) or B (N.C.), 6A @ 28VDC, 1/8 hp.
@ 120VAC, 125VA @ 120VAC. Off state impedance is 20KΩ minimum.
Latching or non-latching.
Process or deviation.
Separate high and low values.
Alarm silencing (inhibit) on power up for Alarm 1.
Retransmit Output
4-20mA into a 600Ω maximum load, non-isolated. Retransmit of process
or set point. User selectable range.
0-5VDC into a 10KΩ minimum load, non-isolated. Retransmit of process
or set point. User selectable range.
Accuracy
Calibration Accuracy and Sensor Conformity: ± 0.1% of span, ± 1 LSD,
77°F ± 5°F (25°C ± 3°C) ambient & rated line voltage ± 10%.
Accuracy Span: 1000°F or 540°C minimum.
Temperature Stability: 0.1°F/°F (0.1°C/°C) change in ambient.
Voltage Stability: ± 0.01% of span / % of rated line voltage.
Communications
Serial data communications.
RS-422A or RS-423A (RS-232C compatible) or EIA-485, user selectable.
ANSI X3.28 protocol, or XON/XOFF protocol.
Isolated.
Data logging.
#6 compression type screw terminals.
Agency Approvals
UL and CSA pending.
Terminals
#6 compression type screw terminals.
Power
120/240VAC +10%, -15%, 50/60Hz, ± 5%.
16VA maximum.
Data retention upon power failure via nonvolatile memory.
Operating Environment
32 to 149°F/0 to 65°C.
0 to 90% RH, non-condensing.
Dimensions
Height: 3.8 in 97 mm
Width: 3.8 in 97 mm
Overall depth: 7.0 in 178 mm
Behind panel depth: 6.0 in 153 mm
Weight: 2.5 lb max. 0.4 kg