WATSON SEVEN - Page 6

6 Seven/Relay Workbench Assembly | INS-SWORKBENCH
Raceway Modular Power
A
Route Jumpers through raceway channel
B
Connect jumpers to the receptacle blocks.
The connectors are keyed for the 4-circuit, 8-wire
system. Tampering with, or clipping, the molded
pins will result in short circuit and void the Watson
warranty.
Extended Connector Kit
(Optional)
A
Connect the 15” jumper and coupler
to the standard length jumper.
B
Connect the jumper to the
receptacle blocks then secure and
clamp the block to the bottom of the
extended connector with #10-32x⅜”
screw.
Note — Use the jumper
grid to determine the
correct length to use.
Note — Underside shown
for clarity.
Note — Maximum
segments connected:
12 standard power, 6
heavy power.
Note — Connections are keyed to snap in
one way with a positive click. Do not modify
the jumper or harness block as this creates a
safety hazard and voids the warranty.
Note — Connections are keyed to
snap in one way with a positive click.
Do not modify the jumper or harness
block as this creates a safety hazard
and voids the warranty.
STANDARD
POWER
SEGMENT 2 WIDTH
48 54 60 66 72 78 84
SEGMENT 1 WIDTH
48
37 43 43 49 49 55 55
54
43 43 49 49 55 55 61
60
43 49 49 55 55 61 61
66
49 49 55 55 61 61 67
72
49 55 55 61 61 67 67
78
55 55 61 61 67 67 73
84
55 61 61 67 67 73 73
HEAVY
POWER
SEGMENT 1 WIDTH
48 54 60 66 72 78 84
SEGMENT 1 WIDTH
48
31 37 37 43 43 49 49
54
37 37 43 43 49 49 55
60
37 43 43 49 49 55 55
66
43 43 49 49 55 55 61
72
43 49 49 55 55 61 61
78
49 49 55 55 61 61 67
84
49 55 55 61 61 67 67
5.
6.
B
B
B
A
A
A