WATT AGE Live Wire - Section 2: Tools and Supplies Required

5
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
Here's a List of What We Used to Finish Our Live Wire EP:
IMPORTANT
The part numbers listed for the Hitec receiver, Cirrus servos and Cirrus Y-Harness are compatible with Hitec and JR (receiver is
compatible with Hitec only) radio control systems. These items are also available with connectors that are compatible with Futaba
and Airtronics radio control systems. (Micro 555 receiver is also available for Airtronics, Futaba and JR radio systems.) The Wattage
IC-15A ESC is compatible with Futaba, JR, Hitec and Airtronics Z.
When you purchase the Hitec Micro 555 receiver, you must also purchase a Hitec brand crystal compatible with the receiver. The
crystal must also be on the same frequency as your transmitter. Note that the Micro 555 receiver uses a dual conversion FM
Hitec crystal.
❑ Kwik Bond 5 Minute Epoxy # 887560
❑ Lightweight Oil or Vaseline
❑ # 0 Phillips Head Screwdriver
❑ # 1 Phillips Head Screwdriver
❑ Magnum Z-Bend Pliers # 237473
❑ Wire Cutters
❑ Needle Nose Pliers
❑ Adjustable Wrench
❑ Excel Modeling Knife # 692801
❑ Scissors
❑ Electric or Hand Drill
❑ Assorted Drill Bits
❑ Ruler
❑ Pencil
❑ Masking Tape
❑ Builder's Triangle
❑ 220 Grit Sandpaper w/Sanding Block
❑ Push-Pins
❑ Paper Towels
❑ Rubbing Alcohol
❑ NHP Epoxy Mixing Sticks # 864204
❑ NHP Epoxy Mixing Cups # 864205
❑ K&S 30 Watt Soldering Iron # 598120
❑ Heat-Shrink Tubing (Assorted Sizes)
❑ Solder
❑ Hair Dryer or Covering Heat Gun
SECTION 2: TOOLS AND SUPPLIES REQUIRED
QTY. 1 759118 Hitec Micro 555 5Ch. Receiver
Hitec Dual Conversion FM RX Crystal
QTY. 4 444052 Cirrus CS-10 Super-Micro Servos
QTY. 1 444728 Cirrus Y-Harness
QTY. 1 128486 Wattage IC-30A Micro ESC
QTY. 1 128538 Wattage 8 Cell 800Mah 5/4AAA NiMH Flight Battery
QTY. 1 130108 Wattage PF-12 AC/DC Park Flyer Charger
QTY. 1 625085 Deans Ultra-Plug Connector
3M 3/4" Wide Clear Plastic Tape - Available at Most Hardware Stores
Note: To minimize current loss, we suggest soldering
the motor wires directly to the ESC and replacing the
stock Tamiya-style connectors on your battery and ESC
with a high-quality Dean's Ultra-Plug.