5
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
For Aerobatic Flying with Mixing Capability We Recommend:
Hitec 8 Channel Super-Slim Receiver (remove case for lighter weight)
Hitec Dual Conversion RX Crystal
P/N 444052 Cirrus CS-10 Micro Servos (4)
P/N 128486 Wattage IC-30A ESC
P/N 128538 Wattage 8 Cell 800Mah NiMH Flight Battery
P/N 130103 Wattage 7-8 Cell 1 amp AC/DC Peak Charger
IMPORTANT
The part numbers listed for the Cirrus servos and Wattage ESCs are compatible with Hitec and JR receivers. These items
are also available with connectors that are compatible with Futaba and Airtronics receivers.
When you purchase a Hitec receiver, you must also purchase the Hitec brand crystal compatible with the receiver. The
crystal must also be on the same frequency as your transmitter. Note that the Cirrus MRX-4 Micro Receiver uses a single
conversion Hitec crystal. A dual conversion crystal will not work with it.
We have organized the parts as they come out of the box for easier identification during assembly. Before you begin
assembly, group the parts like we list them below. This will ensure that you have all of the parts before you begin
assembly and it will also help you become familiar with each part. If you find any parts missing or damaged, please
contact us below:
AIRFRAME ASSEMBLIES
❑ {1} Fuselage w/Plywood Motor Mount
❑ {1} Left Wing Panel
❑ {1} Right Wing Panel
❑ {1} Horizontal Stabilizer w/Elevator
❑ {1} Vertical Stabilizer w/Rudder
❑ {2} Sheet-Foam Ailerons
KIT CONTENTS
Wattage Customer Service
18480 Bandilier Circle
Fountain Valley CA 92728
Phone: (714) 963-0329 Fax: (714) 964-6236 E-mail: service@globalhobby.net
LANDING GEAR ASSEMBLY
❑ {1} Prebent Main Gear Wire
❑ {2} Main Gear Wheels
❑ {2} Nylon Wheel Retainers
MOTOR ASSEMBLY
❑ {1} 370 Motor w/Gear Box
❑ {1} 7.5 x 5 Propeller
❑ {1} 3mm Flat Washer
❑ {2} 3mm Hex Nuts
❑ {3} 3mm x 12mm Wood Screws
Kit Contents Continued on Next Page
To Next Page
Loading...