9
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
Step 2: Installing the Fuselage Reinforcement Board
❑ Using the tip of your modeling knife, carefully remove
the die-cut pieces out of both the middle and the outer edges
of the fuselage reinforcement board.
❑ Carefully bend each side of the reinforcement board down
at a 90º angle along the two scribe lines.
❑ Remove the protective backing from the reinforcement
board.
❑ Carefully adhere the reinforcement board to the fuselage.
To align it properly, the front edge of the board should be even
with the back of the plywood motor mount and the sides of the
board should follow the sides of the fuselage.
❑ Using a modeling knife, carefully cut away and remove
the foam from within the three cutouts in the reinforcement
board.
Step 3: Installing the Wing Hold-Down Dowels
❑ Using a 1/8" drill bit, drill four holes through the fuselage
sides using the die-cut holes in the sides of the reinforcement
board for reference.
☛
To prevent tearing up the foam, don't drill the hole using
an electric drill. It is better to use your fingers to slowly twist
the drill bit.
To Next Page
Loading...