H2O-DWCBTP100
IOM-WQ-H2O-DWCBTP100
Installation, Operation and
Maintenance Manual
Total PFAS Filtration System
Model: H2O-DWCBTP100
Please read carefully before proceeding with
installation. Your failure to follow any attached
instructions or operating parameters may lead to the
product’s failure.
Keep this Manual for future reference.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
If you are unsure about installing your WATTS water filter, contact
a WATTS representative or consult a professional plumber.
Test the water periodically to verify that the system is performing
satisfactorily.
Failure to install the system correctly voids the warranty.
Handle all components of the system with care. Do not drop,
drag or turn components upside down.
H2O-DWCBTP100 is certified by
IAPMO R&T to meet NSF/ANSI 42
for the reduction of Chlorine, Taste
and Odor, and Particulates Class 1;
NSF/ANSI 53 for the reduction
of Total PFAS, Lead, Cyst and
Asbestos; NSF/ANSI/CAN 372 for
low lead Compliance; NSF/ANSI
401 for reduction of Micro-Plastics;
and to CSA B483.1 as verified and
substantiated by test data.
Refer to enclosed warranty for operating parameters
to ensure proper use with your water supply.
To Next Page
Need help?
General
