Need help?Do you have a question about the Wattson Solar Plus and is the answer not in the manual?
Connect sensor clips to single-core cables to measure electrical power.
Plug sensor leads into transmitter sockets for usage and generation data.
Install batteries or connect the DC power supply to the transmitter.
Switch between Number, Clock, and Colour display modes using the button.
Interprets electricity usage via coloured lights, including low, average, high, and export.
Change display units (watts, cost, carbon) by tilting the device on its base.
Includes turning off, resetting, charging, and portability guidelines.
Covers re-pairing transmitters and understanding signal transmission range.
Details power usage in different modes and internal battery life.
Addresses no lights, out of range, zero readings, and sensor clip problems.
Emphasizes consulting an electrician for safe sensor clip attachment.
To Next Page
General