wattstopper LMSW-102 - User Manual

LMSW-101/102/103/104/108
Digital Lighting Management
Low Voltage Switches
THESE UNITS ARE
PRESET FOR
PLUG n’ GO
OPERATION,
ADJUSTMENT
IS OPTIONAL.
For full operational details, adjustment and more
features of the product, see the DLM System
Installation Guide at www.wattstopper.com
Installation shall be in accordance with all applicable
regulations, and codes.
To be connected to a Class 2 power source only.
Class 2 Device Wiring Only – Do Not Reclassify and Install
as Class 1, or Power and Lighting Wiring.
Wire connections shall be rated suitable for the wire size
(lead and building wiring) employed.
Voltage ................................................................................ 24VDC
Current Consumption ............................................................ 5mA
Power Supply .............. Watt Stopper/Legrand Room Controllers
Connection to the DLM Local Network ...................2 RJ-45 ports
DLM Local Network Characteristics:
Provides low voltage power over Cat 5e cable (LMRJ).
Supports up to 24 communicating devices, including 4
LMRC-10x or LMPL-101 max per each DLM Local Network.
Free topology up to 1,000ft of low voltage cable.
Environment ................................................. For Indoor Use Only
Operating Temperature ....................32° to 131°F (0° to 55°C)
Storage Temperature ...................... 23° to 176°F (-5° to 80°C)
Relative Humidity ...........................5 to 95% (non condensing)
Patent Pending
CONNECTIVITY
The illustrations below show examples of free-topology
wiring. The LMSW switches communicate to all other Digital
Lighting Management devices connected to the low voltage
Quick Start Guide
Line
Voltage
Room
Controller
J-Boxes
Daylight Sensor
SwitchSwitch
Corner Mount
Sensor
Ceiling Mount
Sensor
DLM Local Network
Low Voltage
LMRJ Cables
Loads
2
1
Line/Hot
Black wire
Neutral
White wire
Red wire
to Load A (1)
Yellow wire
to Load B (2)
LMRC
102
Room
Controller
J Box
Corner Mount
Occupancy
Sensor
Switch
To
Load/Line
(Class 1 wiring)
DLM Local Network
(low voltage, Class 2)
LMRJ Cables
LMSW-108LMSW-104LMSW-103LMSW-102LMSW-101
MOUNTING THE SWITCH
Red LED
Blue LED(s)
On/Off Button(s)
Conguration Button
(behind switch plate)
BUTTONS AND INDICATORS
WARNING: Do Not Install To Cover a Junction Box
Having Class 1, 3 or Power and Lighting Circuits.
DLM Local Network, regardless of their position on the DLM
Local Network.

wattstopper LMSW-102 Specifications