Not sure which ports to connect to? Some devices have both Wi-Fi and Cellular external
antenna ports. Make sure to attach your antenna(s) to your router’s cellular ports and not it’s
Wi-Fi ports. To help you identify which ports to connect to, refer to your router’s manual, our
device-specic guides at waveform.com/hotspot-guides, or feel free to reach out to us.
Is holding all four Log Periodic Antennas difcult? Have someone assist you with moving and
aiming all four antennas at the same time. If that isn’t possible, but you know your router’s
primary cellular antenna port, connect just one of the antennas to that port for this process.
Running Speed Tests
Since the goal is improved data rates, it makes sense to use a speed test app to measure your
data rates through your cellular router’s Wi-Fi.
If you’re testing with a phone, download our favorite speed test app (“Speedtest by Ookla”) by
visiting this URL: waveform.com/speedtest. For testing with a laptop, visit speedtest.net.
Go ahead and run a couple of speed tests from a device connected to your router’s Wi-Fi.
You’ll notice your results uctuate a between tests – that’s normal.
Head outside and run 1-2 speed tests for each position and direction you try, then write
down each of your results in the next page.
How to Position & Aim
Finding the right antenna location and direction takes some patience, but spending time to
get it right can have a big impact on your system’s performance. Here are all the locations and
directions where we recommend testing your MIMO antenna(s):
Don’t just go to the highest point of the roof! While signal is generally stronger the higher you
go, there’s also often more interference. We’ve found it’s often better to mount the antenna(s)
on the side of the building where the structure can shield the antennas from interference.
Once you’ve found the best antenna location and direction, move on to section 5 below to
get ready for your nal installation.
8
To Next Page
Loading...
